Menu  

Appliance Repair Colo Iowa

Hometown Hero Appliance Repair Rated out of 5 stars based on customer reviews

We serviced a
FRIGIDAIRE REFRIGERATOR
Model GRFC2353AF2
Near Colo, IA 50056
David M.
Job Details: 04/06/2024
Customer has low water pressure and experiencing freezing produce in bottom right deli drawer. Tested damper and fresh food damper opens and closes appropriately. The bottom right deli drawer does have the vent from the freezer and will be the coldest section of the fridge. As for the water pressure it is dispensing just less than 8oz after 10 seconds which is close to manufacturer recommendation. The house is on a whole home water filter system. Provided customer with information on a bypass filter that he can purchase.
We serviced a
SAMSUNG RANGE/COOKTOP GS
Model NX58H5600SS/AA
Near Colo, IA 50056
Rory
Job Details: 04/01/2024
Customer states oven is not heating upon arrival. Found of an igniter pulling 0 Amps recommended replacing of an igniter customer approved repair .replaced oven igniter unit now operating properly job complete.; dspstn on spec-tagged invntry: 1 5303935066 UNI.FLAT IGNITOR KIT , used 1 SHIPPING ( PARTS HANDLING) from stock
We serviced a
GE RANGE/COOKTOP EL
Model JB655YKSS
Near Colo, IA 50056
David M.
Job Details: 03/21/2024
The faceplate graphic was misaligned. Pulled board, and reseated faceplate correctly.
We serviced a
GE WASHER
Model GTW465ASN9WW
Near Colo, IA 50056
Dillon
Job Details: 04/28/2023
Customer states of the machine clumped up her clothes and while it was spinning the machine walked itself out of the closet. I then informed customer that in order to fix this issue that the water level will need to be set to max fill and that will fix the entire issue. I then did this fix and ran the machine on a full cycle and found that the machine was operating properly. Job complete.
We serviced a
GE WASHER
Model GTW465ASN9WW
Near Colo, IA 50056
Dillon
Job Details: 04/28/2023
Customer states of the machine clumped up her clothes and while it was spinning the machine walked itself out of the closet. I then informed customer that in order to fix this issue that the water level will need to be set to max fill and that will fix the entire issue. I then did this fix and ran the machine on a full cycle and found that the machine was operating properly. Job complete.